UNI-T UT50E Especificações descarregar pdf (Página 22)

Measurement Operation(10)

l When continuity testing has been completed,

disconnect the connection between the testing leads

and the circuit under test.

G. Frequency Measurement (see figure 7)

( figure 7)

red black

Warning

To avoid harm to you or damages to the Meter, do

not attempt to measure voltages higher than 60V in

DC or 30V rms in AC although readings may be

obtained.

When the frequency signal to be tested is higher than

30V rms, the Meter cannot guarantee accuracy of

the measurement.

The frequency measurement ranges is 20kHz. To

measure frequency, connect the Meter as follows:

1. Insert the red test lead into the VΩ

Cterminal and

the black test lead into the COM terminal.

2. Set the rotary switch to an appropriate measurement

position in kHz range.

3. Connect the test leads across with the object being

measured.The measured value shows on the display.

Model UT50E: OPERATING MANUAL

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 35 36

Sem comentários

UNI-T UT50E Especificações Página 22