UNI-T UT501 Manual de Instalação descarregar pdf (Página 8)

DMX 512 TO MICROPLEX

In this application, DMX 512 is converted to Microplex..

CONNECTOR OPERATION

Microplex IN Not used

Microplex OUT Output Microplex (64 or 128)

DMX IN Input DMX 512

DMX out Pass through DMX 512

MIDI / Analog Not used

Luma-net Not Used

RS-232 Not Used

JUMPER LOCATIONS

P4 & 5 P7 JP6 & 7 JP8 & 9 JP10 JP11 JP12 JP13

CLOSED CLOSED N/A N/A 2-3 2-3 N/A 2-3

P6 P8 JP1 DMX OUT CABLE

*CLOSE TO TERM

DMX

N/A N/A JP4

DIPSWITCH POSITIONS

C1 C2 C3 C4 ADDRESS 1 - 7 A8

DN UP DN DN STARTING DMX CHANNEL FOR MICROPLEX BY 16 INCR. DN:64

Microplex channel 1 is equal to starting DMX channel. Address switch 1 - 6 sets starting DMX channel in

increments of 16. See chart at the end of this manual.

Microplex output is sent as either 64 or 128 channels, depending on the setting of switch A8.

*DMX should only be terminated internally if IF501 will be always last unit at end of DMX line. A better way

to terminate is to connect 120ohm resistor to a female DMX cable end (pins 2-3) and plug it into the pass-through

of the last unit on the DMX line.

INTERFACE UNIT

Software Revision 1.05, Version A DMX 512 TO MICROPLEX

NSI CORPORATION 8

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 25 26

Sem comentários

UNI-T UT501 Manual de Instalação Página 8